Mitsubishi Starion P0171 Engine Trouble Code
What is Mitsubishi Starion P0171?
Mitsubishi Starion P0171 code can indicate a faulty oxygen sensor, which may eventually damage the catalytic converter (repair cost: $2,000–$2,200). Professional diagnosis costs around $200–$210. Oxygen sensors are often straightforward to replace — check your owner's manual for location and instructions. This issue should be addressed promptly to prevent further damage.
P0171 on the Mitsubishi Starion
A known issue on the Mitsubishi Starion is that aftermarket air filter upgrades can inadvertently trigger P0171. High-flow filters alter the intake resonance frequency, causing the MAP sensor to report pressure readings outside factory calibration.
Code Information
| Code Type: | OBD-II Powertrain (P) Trouble Code |
| System: | Powertrain |
| Vehicle: | Mitsubishi Starion |
| Brand: | Mitsubishi |
| Model: | Starion |
| Code: | P0171 |
P0171 Mitsubishi Starion Symptoms
Check Engine Light
Illuminated Mitsubishi Starion dashboard warning
Engine Stalling
Engine stops unexpectedly or misfires
Performance Issues
Reduced power or acceleration on the Mitsubishi Starion
Starting Problems
Difficulty starting the engine
Poor Fuel Economy
Increased fuel consumption on the Mitsubishi Starion
Increased Emissions
Failed emissions test due to P0171
P0171 Code Structure
Understanding what each digit means in the P0171 powertrain trouble code:
| P | 0 | 1 | 7 | 1 |
|---|---|---|---|---|
| Powertrain Code | Intake Valve Control Solenoid Circuit Low | Fuel Rail/System Pressure — Too High | Cylinder 10 Contribution/Balance Fault | Crankshaft Position Sensor A Circuit Low Input |
How to Fix Mitsubishi Starion P0171
Diagnostic Steps:
Regarding P0171, carefully inspect the wire harness near the intake manifold bracket, best accessed from below near the oil filter. Look for chafing, pinching, or damaged insulation.
Repair Solution:
Power steering pressure switch monitors system operation. If pressure changes are not detected after calibrated speed transitions, this DTC sets. Verify PSP switch operation and check for circuit opens or shorts.
Technical Notes:
P0171 DTCs can be triggered by upstream issues. For example, a dirty MAF sensor may cause incorrect fuel-trim adjustments, leading oxygen sensors to report mixture problems. Address root causes first.
Mitsubishi Starion P0171 Repair Cost
For Mitsubishi Starion owners, budget the following for a P0171 repair: EGR valve cleaning $80–$120 or replacement $250–$450, intake manifold gasket $120–$200, and a post-repair reset and road test. Total: $350–$650 at an independent garage.
P0171 Description
P0171 OBD-II Trouble Code: With the Air/Fuel Mixture Ratio Self-Learning Control, the actual mixture ratio can be brought closely to the theoretical mixture ratio based on the mixture ratio feedback signal from the heated oxyge
Main Cause
The primary reason for P0171 OBD-II Engine Trouble Code is: Fuel Rail/System Pressure — Too High.
Common P0171 Misdiagnosis on the Mitsubishi Starion
A common error on the Mitsubishi Starion is attributing P0171 to the crankshaft position sensor when the real fault is a damaged flywheel ring gear. The missing tooth pattern created by ring gear damage is intermittent and generates the same signal anomaly.
DIY Repair Guide: P0171 on Mitsubishi Starion
When attempting DIY diagnosis of P0171 on your Mitsubishi Starion, a smoke machine test is the gold standard for finding vacuum leaks. Rental tools are available from most auto parts stores for $0–$20/day, or you can fabricate a makeshift tester using a hand vacuum pump and soapy water spray.
Preventing P0171 on the Mitsubishi Starion
The Mitsubishi Starion coolant temperature sensor plays a role in fuel enrichment during warm-up. Replacing it as a precaution at 80,000 miles ($25–$40 DIY) prevents the faulty cold-start enrichment that can lead to P0171.
Frequently Asked Questions — Mitsubishi Starion P0171
A: Almost certainly yes. Most faults that trigger P0171 cause the ECU to operate in open-loop mode or apply overly rich fuel trims, both of which increase fuel consumption by 5–15%. Resolving the fault promptly pays for itself in fuel savings over time.